Adding Ink to your Xstamper
⚠️ Use only Xstamper Refill Ink. Other inks may clog the micropores and void the warranty.
⏳ After re-inking, let the stamp sit for up to 24 hours to reach full saturation.
⏳ After re-inking, let the stamp sit for up to 24 hours to reach full saturation.
📦 Models: N04, N05, N10, N11, N12, N13, N16, N24, N37
Remove the handle and place 2–4 drops of ink in the openings on either side of the spring.
📦 Models: N06, N30, N32, N44, N48, N49, N51, N53, N56, N57, N59, N60, N62
Remove the handle and place 2–4 drops into the center opening of the mount.
📦 Models: N14, N18, N22, N26, N27, N28
Slide the impression cartridge out and place 2–3 drops in each of the 4 openings.
📦 Models: N40, PN40, N42
Slide the cartridge out and place 2–3 drops into the ink opening.
📦 Models: N75, N77, N78, N79, N85, N89 (XpeDater Models)
Add a few drops of ink into both the XpeDater base and the travel cap.
📦 Models: N80, N81, N82, N83 (Versadater Cartridge Models)
Remove the Versadater from the frame. Remove the impression frame and apply 2–3 drops of ink into the frame.